Kia Sportage: Cylinder Block
READ NEXT:
Components
Piston ring
Snap ring
Piston
Connecting rod
Connecting rod upper bearing
Piston pin
Connecting rod lower bearing
Connecting rod bearing cap
Connecting Rod
1. Check the connecting rod end play.
Using a feeler gauge, measure the end play while moving the connecting rod back
and forth.
End play:
Standard : 0.10 ~ 0.25mm (0.0039 ~ 0.0
SEE MORE:
Repair procedures
Inspection
[Fuel pump]
1. Turn the ignition switch OFF, and then remove battery (-) cable.
2. Remove the fuel pump assembly.
3. Check motor operation by fuel pump connector (A) connecting power (No.4) and
ground (No.5).
-
Fuel sender signal
Fuel sender gr
Preparation for assembly
1. Spot weld finish
Use a disk grinder or similar tool to finish spot weld
mark. Do not grind more than is necessary to smooth
surface.
2. Panel preparation
Repair any bent or uneven areas with a hammer to
improve the assembly process.
3. Cutting a rough area for
Components and ComponentsLocation | Disassembly - Repair procedures
