Kia Sportage: Replacing license plate lamp (Bulb type)

- Turn off vehicle and disconnect the
negative terminal from the battery.
- Using a flat-blade screwdriver, gently
pry the lens cover from lamp housing
- Remove the bulb by pulling it straight
out.
- Install a new bulb in the socket.
- Align the lens cover tabs with the
lamp housing notches and snap the
lens into place.
Replacing map lamp (Bulb type)

WARNING
Interior lamps
Prior to working on the Interior lamps,
ensure that the "OFF" button is
depressed to avoid burning your fingers
or receiving an electric shock.
- Turn off vehicle and disconnect the
negative terminal from the battery.
- Using a flat-blade screwdriver, gently
pry the lens cover from lamp housing.
- Remove the bulb by pulling it straight
out.
- Install a new bulb in the socket.
- Align the lens cover tabs with the
lamp housing notches and snap the
lens into place.
CAUTION
Be careful not to dirty or damage the
lens, lens tab, and plastic housings.
Replacing room lamp (Bulb type)

WARNING
Interior lamps
Prior to working on the Interior lamps,
ensure that the "OFF" button is
depressed to avoid burning your fingers
or receiving an electric shock.
- Turn off vehicle and disconnect the
negative terminal from the battery.
- Using a flat-blade screwdriver, gently
pry the lens cover from lamp housing.
- Remove the bulb by pulling it straight
out.
- Install a new bulb in the socket.
- Align the lens cover tabs with the
lamp housing notches and snap the
lens into place.
CAUTION
Be careful not to dirty or damage the
lens, lens tab, and plastic housings.
READ NEXT:
WARNING
Interior lamps
Prior to working on the Interior lamps,
ensure that the "OFF" button is
depressed to avoid burning your fingers
or receiving an electric shock.
Turn off v
Use the information in the following sections
to keep the exterior and interior of
your vehicle clean.
Exterior care
Use the information in the following sections
to maintain the exterior of your
SEE MORE:
The driver's and front passenger's seats
are equipped with a headrest for the
occupant's safety and comfort.
The headrest not only provides comfort
for the driver and front passenger, but
also helps protect the head and neck in
the event of a rear collision.
For maximum effe
Description and Operation
Description
1. Mode
Configuration State
All sensors should be in the Low Line (Base) state.
In Low Line (Base) configuration, sensor transmissions occur every 3
minutes 20 seconds (nominal) and
pressure is measured every 20 seconds.
Normal