Kia Sportage: High tension steel sheet used area
Kia Sportage - Second generation (JEKM) (2005-2015) - Body Workshop Manual / Body structure / High tension steel sheet used area
- Radiator support panel
- Center floor panel
- Roof panel (Without sunroof)
- Fender panel & Hood panel & Tail gate panel
READ NEXT:
Radiator support panel
Radiator support panel complete
Fender apron panel
Fender apron panel assembly
Front side outer member assembly
Cowl & Dash panel
Cowl panel complete
Cowl side outer pan
Center floor panel
Front seat cross rear member assembly
Center floor panel
Side sill inner panel assembly
Center floor side outer member assembly
Center floor side inner member assembly
Propeller shaft m
Roof panel (Without sunroof)
Roof front rail assembly
Roof rear rail assembly
Roof panel
Roof center No.1 rail
Roof center No.2 rail
Roof center No.3 rail
Roof panel (With sunroof)
Roof front rail assembly
SEE MORE:
Introduction
If you have a flat tire (with tire mobility kit) (if equipped)
For safe operation, carefully read and
follow the instructions in this manual
before use.
Compressor
Sealant bottle
The Tire Mobility Kit is a temporary fix to
the tire and have your vehicle inspected
by an authorized K
Turn Signal Lamp | Room Lamp
Repair procedures
Removal
Rear Turn Signal Lamp
1. Disconnect the negative (-) battery terminal.
2. Remove the rear bumper.
(Refer to BD group - "Rear Bumper")
3. Disconnect the connector. Remove the rear turn signal lamp (A) after loosening 5 screws.
4. Replace the bulb (A
Content
- Home
- Kia Sportage - Fifth generation (NQ5) - (2022-2026) - Owner's Manual
- Kia Sportage - Second generation (JEKM) (2005-2015) - Body Workshop Manual
- Kia Sportage Third generation (SL) - (2011-2016) - Service and Repair Manual
- Sitemap
- Top articles
