SportageMotor

Kia Sportage: Heated steering wheel

Kia Sportage - Fifth generation (NQ5) - (2022-2024) - Owner's Manual / Features of your vehicle / Steering wheel / Heated steering wheel

When the ignition switch or ENGINE START/STOP button is in the ON position, pressing the heated steering wheel button warms the steering wheel. The indicator on the button will illuminate.

Heated steering wheel

To turn the heated steering wheel off, press the button once again. The indicator on the button will turn off.

  • The heated steering wheel defaults to the OFF position whenever the ignition switch or ENGINE START/STOP button is in the ON position.

NOTICE

The heated steering wheel will turn off automatically approximately 30 minutes after the heated steering wheel is turned on.

CAUTION

Do not install any type of grip cover for the steering wheel, it may impair the function of the heated steering wheel system.

When cleaning the heated steering wheel, do not use an organic solvent such as paint thinner, benzene, alcohol and gasoline. Doing so may damage the surface of the steering wheel.

If the surface of the steering wheel is damaged by a sharp object, damage to the heated steering wheel components could occur.

WARNING

If the steering wheel becomes too warm, turn the system off. The heated steering wheel may cause burns even at low temperatures, especially if used for long periods of time.

Horn

To sound the horn, press the area indicated by the horn symbol on your steering wheel (see illustration).

The horn will operate only when this area is pressed. Check the horn regularly to be sure it operates properly.

CAUTION

Do not strike the horn severely to operate it, or hit it with your fist. Do not press on the horn with a sharp-pointed object.

    READ NEXT:

     Mirrors

     Inside rear view mirror

    Mirrors This vehicle is equipped with inside and outside rear view mirrors to provide views of objects behind the vehicle. Inside rear view mirror Adjust the rear view mirror so that the center

     Automatic-Dimming Night Vision Safety (NVS) Mirror (if equipped)

    The NVS Mirror automatically reduces glare by monitoring light levels in the front and the rear of the vehicle. Any objects that obstructs the light sensor will degrade the automatic dimming cont

    SEE MORE:

     Replacing license plate lamp (Bulb type)

    Turn off vehicle and disconnect the negative terminal from the battery. Using a flat-blade screwdriver, gently pry the lens cover from lamp housing Remove the bulb by pulling it straight out. Install a new bulb in the socket. Align the lens cover tabs with the lamp housing not

     Immobilizer Control Unit | Antenna Coil

    Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") 3. Remove the steering column assembly. (Refer to the ST group - "steering column & shaft") 4. Disconnect the connector

    Content